2004 Toyota Tundra 2wd Front Wheel Bearing

Fix Your Toyota Tundra Wheel Bearing Issues with Ease

Easy, Simple, and Fixable Solution

Are you facing troublesome noises or vibrations in your 2000-2006 Toyota Tundra? It's likely an issue with the wheel bearing. But don't fret – replacing it is a straightforward task that you can handle yourself. Get ready to fix your vehicle like a pro with our step-by-step guide.

Affected Models

This guide applies to the following Toyota Tundra models equipped with either 6-cylinder (34L), 8-cylinder (47L), or 8-cylinder (40L) engines:

• DLX
• Limited
• SR5

Identifying the Issue

Common symptoms of a worn-out wheel bearing include:

• Grinding or rumbling noises while driving
• Vibrations in the steering wheel or seat
• Loose or wobbly wheel when lifted

Required Tools and Parts

Before starting, gather these essential tools and parts:

• Lug wrench
• Socket wrench with 22mm and 32mm sockets
• Torque wrench
• Pry bar
• Replacement wheel bearing

Step-by-Step Replacement Guide

Follow these steps to replace the front axle hub inner bearing on your Toyota Tundra:

1. Park the vehicle on a flat surface and engage the parking brake.
2. Loosen the lug nuts on the affected wheel, but do not remove them completely.
3. Jack up the vehicle and support it securely with jack stands.
4. Remove the lug nuts and the wheel.
5. Disconnect the brake caliper from its bracket and secure it out of the way.
6. Remove the two bolts holding the caliper bracket to the knuckle.
7. Use a pry bar to separate the caliper bracket from the knuckle.
8. Remove the axle nut using the 32mm socket.
9. Separate the hub assembly from the knuckle by pulling or tapping it with a hammer.
10. Use a 22mm socket to remove the three bolts holding the bearing to the knuckle.
11. Install the new bearing by pressing it into place using a press or a suitable tool.
12. Reinstall the hub assembly and tighten the axle nut to 181 ft-lbs.
13. Reattach the caliper bracket to the knuckle and tighten the bolts to 73 ft-lbs.
14. Reconnect the brake caliper and tighten the bolts.
15. Install the wheel and tighten the lug nuts to 80 ft-lbs.
16. Lower the vehicle and remove the jack stands.

Conclusion

Replacing the wheel bearing on your Toyota Tundra is a relatively straightforward task that can save you time and money. By following our step-by-step guide, you can effectively resolve this common issue and ensure a smooth and noise-free ride.